• Die set for Press Studs(Ring Type, 0.6")
• Made of high strength steel
• Needs Hand-Press Tool for attaching Press Studs.

Specifications of Dies:
• Die for Cap: refer to the photo
Put it in the hole at the bottom of Hand-Press Tool.
Height: 23mm
Diameter: 22mm

• Die for Socket: refer to the photo
Screw up to the above point of Hand-Press Tool.
Height: 32mm
Diameter: 18mm

• Die for Post: refer to the photo
Put it in the hole at the bottom of Hand-Press Tool.
Height: 31mm
Diameter: 22mm

• Die for Stud: refer to the photo
Screw up to the above point of Hand-Press Tool.
Height: 30mm
Diameter: 15mm

Instruction:
• Instruction by Hand-Press Tool