Our Vinyl Holder has been reproduced authentically to the 50s original. This unique attaching system for leather name plates can be seen only on the USAF flight clothing supplied during 50-60s. Vinyl Holder was replaced to Velclo tape from early 70s at US Military.

Vinyl Holder for USAF Leather Name Plate
Supplied Era: 50s to early 60s
Material: Clear Vinyl Sheet
Thickness: 0.5mm
Size: 6.2 x 12.1cm
How to sew and set the name plate to the holder:
1) Refer to the illustration where to sew on.
2) Sew it on the jacket at the upper side, right side and lower side as the photo.
3) Put the name plate into the holder.
4) Fold the left tongue back to the name plate.
5) Remove the name plate when washing.
Note) Vinyl holder is expendables. Replace when gets damaged.